Where to buy hovertrax in Dubai, UAE.
IO Hawk Personal Transporter Black Specification 4.0 Remote Control The IO Hawk comes with 2 remote controls with maximum operating range of 15 feet (5 meters). A. Power OFF (A) Button: When the device is powered on, press and hold button A for 3 seconds to power off. NOTE: You must press the power button on the actual device to power the IO HAWK back ON. B. Lock/Unlock (B) Button: While the device is powered on, click the B button to lock your IO HAWK (your battery display will turn red, indicating locked mode). Click the B button again to unlock your IO HAWK (display green/active)
IO Hawk Personal Transporter Black Specification 4.0 Remote Control The IO Hawk comes with 2 remote controls with maximum operating range of 15 feet (5 meters). A. Power OFF (A) Button: When the device is powered on, press and hold button A for 3 seconds to power off. NOTE: You must press the power button on the actual device to power the IO HAWK back ON. B. Lock/Unlock (B) Button: While the device is powered on, click the B button to lock your IO HAWK (your battery display will turn red, indicating locked mode). Click the B button again to unlock your IO HAWK (display green/active)
NOTE: After 10 minutes of no activity, your IO HAWK will always power itself off to conserve battery.
Special Functions Beginner Mode: Press and hold the B button for 3 seconds, your IO HAWK will switch to beginner mode reducing top speed to 3.7mph (6km/h). You will notice the Running Indicator will begin blinking, indicating you are operating in beginner mode. To turn beginner mode off, press and hold the B button on the remote control for 3 seconds. The blinking Running Indicator light will turn off. This indicates that your device is back in standard operating mode. NOTE: In beginner mode, the governor is set at 3mph, (6km/h) whereas in standard operating mode, the governor is set at 6.2mph (10km/h). For your own safety, the IO HAWK will push back if you attempt to exceed the governed speed limit. Recalibrating: When the IO HAWK experiences an error, the Running indicator light will remain red, meaning your IO HAWK will not operate until it is properly recalibrated. To recalibrate, follow these steps: Place the IO HAWK back in its box. Click the B button, the battery light will display red (locked mode). Then press and hold both buttons A and B simultaneously for 2 seconds. You will see both display lights flash yellow. Click the B button again to unlock. Now your IO HAWK has been reset.
Share this
Emoticon Emoticon